An Environmentally Friendly Wbm System Can Prevent Hard Brittle Shale Instability
Abstract
In the Weizhou Southwest oilfields, drilling delays and suspension of wells prior to reaching the targets due to wellbore instability had occurred frequently. The hard brittle shale played a problematic role. Conventional water-based drilling fluids didn’t conquer the problematic formation due to intrinsically performance deficiencies. While Oil based drilling fluids are routinely preferred in the more technically demanding applications, they are cause for increasing concern due to offshore environmental restrictions and expensive disposal costs. An environmentally acceptable water-based drilling fluid was developed to challenge the problematic formation based on the combination of methylglucoside-silicate concept. It stabilized the reactive shale by the same mechanism as did oil-based drilling fluid in preventing shale hydration, pore pressure increase and weakening of shale by effectively developing sufficient osmotic force to offset hydraulic and chemical forces acting to cause filtration flux into the hard brittle shale. A field trial was initiated on the CNOOC 931 platform in Weizhou oilfield. The data from the pilot well showed that the novel drilling fluid exhibited excellent inhibition and lubricity which approached or even exceeded oil-based fluids.
Keywords
Full Text:
PDFReferences
Walker, T.O. et al.: “Environmentally Acceptable
Water-Based Mud Can Prevent Shale Hydration
and Maintain Borehole Stability”, paper 27496
presented at the 1994 IADC/SPE Drilling Conference
held in Dallas, Texas, 15-18 February,
Headley, J.A. et al.: “Environmentally Safe Water-
Based Drilling Fluid to Replace Oil Muds for
Shale Stabilization”, paper SPE 29404 presented
at the 1995 SPE/IADC Drilling Conference held
in Amsterdam, Neitherland, 28 February - 2
March, 1995.
Zhang yan, et al.: “Investigation on Formation Damage
Control of the Methylglucoside Fluids”, paper
SPE 39442 presented at the 1998 SPE International
Symposium on Formation Damage Control
held in Lafayette, Louisiana, 18-19 February
Yan Jienian, Feng Wenqiang.: “Design of Drill-in
Fluids by Optimizing Selection of Bridging Particles”,
paper SPE 104131 presented at the 2006
SPE International Oil&Gas Conference and Exhibition
held in Beijing, China, 5-7 December 2006.
Dick M A, Heinz T J, Svoboda C F, and Aston
M.: “Optimizing the Selection of Bridging Particles
for Reservoir Drilling Fluids,” SPE 58793 presented
at the International Symposium on Formation
Damage held in Lafayette, Louisiana, Feb 23-
, 2000: 183-191
DOI: https://doi.org/10.29017/SCOG.32.2.843
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.