An Experimental Study To Assess The Impact Of Inorganic Additives On Water-Based Drilling Fluid Performance
Keywords:
WBM, sodium hydroxide, inorganic additives, rheological, physical propertiesAbstract
Drilling mud plays a crucial role in ensuring safe and cost-effective drilling operations, but it is often contaminated during the process and can significantly impact the mud's properties. Previous studies have largely addressed drilling mud contamination in a general sense, this work provides direct comparative insight into how sodium hydroxide (NaOH) alone and in combination with barite, lime, and calcium sulphate alters key rheological and physical properties of water-based muds (WBM) at a constant temperature of 25 °C. This paper investigates the effects of inorganic additives, specifically NaOH, on the properties of WBM. In this experimental study, six mud samples were prepared alongside a base mud, with three samples contaminated with varying concentrations of NaOH and the other three with different amounts of barite, lime, and calcium sulphate. The study focused on evaluating the rheological and physical properties of the mud at 25°C. The results showed that NaOH positively increased the mud alkalinity up to 12.75, but this was less pronounced as a result of the combinations with other additives like barite and calcium sulphate, reduced to 9.8. This trend is evident when higher NaOH concentrations result in increased fluid loss (≈ 40 ml at around 6 minutes) and decreased gel strength (≈ 13 lb/100 ft² after 10 minutes), which can negatively impact the mud's capacity to retain water and uphold structural integrity. However, the moderate doses of NaOH help in accelerating flocculation in the muds and increases the stability as well.
References
Bourgoyne, A., Chenevert, M., & Young, F. S., 1986, Applied drilling engineering (2nd ed.). Society of Petroleum Engineers. from http://refhub.elsevier.com/S0920-4105(19)30845-9/sref7.
Amanullah, M., 2007, ‘Screening and evaluation of some environment-friendly mud additives to use in water-based drilling Muds’, E&P Environmental and Safety Conference https://doi.org/10.2118/98054-MS.
Alderman, N. J., Ram Babu, D., Hughes, T. L., & Maitland, G. C., 1988, The rheological properties of water-based drilling fluids. In Proceedings of the Xth International Congress on Rheology, vol. 1, pp. 140–142, Sydney, Australia. https://www.researchgate.net/publication/273427481_The_Rheological_Properties_of_Water-Based_Drilling_Fluids
Moore, P. L., 1986, Drilling practices manual (2nd ed.). United States. Retrieved from http://refhub.elsevier.com/S0920-4105(19)30845-9/sref17.
Shakib, J. T., Kanani, V., & Pourafshary, P., 2016, Nano-clays as additives for controlling filtration properties of water–bentonite suspensions. Journal of Petroleum Science and Engineering, vol. 138, pp.257–264. https://doi.org/10.1016/j.petrol.2015.11.018
Zhou, S. S., Song, J. J., Xu, M. B., Xu, P., You, F. C., & Pu, L., 2023, Rheological and filtration properties of water-based drilling fluids as influenced by cellulose nanomaterials: Different aspect ratios and modified groups. Cellulose, vol. 30, no. 6, pp.3667–3683. https://doi.org/10.1007/s10570-023-05100-3
Bayat, A. E., Moghanloo, P. J., Piroozian, A., & Rafati, R., 2018, Experimental investigation of rheological and filtration properties of water-based drilling fluids in presence of various nanoparticles. Colloids and Surfaces A: Physicochemical and Engineering Aspects, vol. 555, pp.256–263. https://doi.org/10.1016/j.colsurfa.2018.07.001
Rig Worker., 2020, Cement contamination. Retrieved January 15, 2023, from https://www.rigworker.com/fluids-2/cementcontamination.html
Chikwe, T. N., & Nwakanma, E. C., 2020, Effects of contaminants on the rheological properties of oil-based muds. International Journal of Scientific Research in Chemical Sciences, 5(1). E-ISSN: 2455-3174.
Broni-Bediako, E., & Amorin, R., 2019, Experimental study on the effects of cement contamination in a water-based mud. Advances in Geo-Energy Research, vol. 3, no. 3, 314–319.
Mahmud, H. B., Mahmud, W. M., Ayanarappan, R., & Elmabrouk, S., 2020, Effect of sodium carbonate and bicarbonate contamination on the rheological properties of
First Author et al. / Mechatronics, Electrical Power, and Vehicular Technology XX (20XX) XX-XX
© 2025 Oil and Gas Testing Center LEMIGAS All rights reserved
11
water-based mud. International Journal of Engineering Research and Technology, vol. 13, pp.1019–1029. ISSN: 0974-3154.
Sylvester, O., Mahmud, K., & Augustina, O., 2022, Investigating the effects of contaminants on the rheological properties of water-based mud. FUPRE Journal of Scientific and Industrial Research, vol. 6, no. 3, pp.148–162.
Dankwa, O. K., Appau, O. P., & Broni-Bediako, E., 2018, Evaluating the effects of monovalent and divalent salts on the rheological properties of water-based mud. Open Petroleum Engineering Journal, vol. 11, no. 1, pp.98–106.
Ebikapaye, J. P., 2018, Effects of temperature on the density of water-based drilling mud. Journal of Applied Sciences and Environmental Management, vol. 22, no. 3, 406. ISSN: 1119-8362.
Khamis, L. A., Isa, A. M., Olatoke, O. J., & Varghese, V., 2020, Evaluation of the effect of cement contamination on the rheological properties of water-based mud: Sodium bicarbonate as a remedy. International Research Journal of Engineering and Technology (IRJET), vol. 7, no. 11, pp.2395–0056 (eISSN), pp.2395–0072 (pISSN).
Darley, H. C. H., & Gray, G. R., 1988, Composition and properties of drilling and completion fluids (5th ed.). Gulf Professional Publishing.
Dhiman, A. S., 2012, Rheological properties and corrosion characteristics of drilling mud additives (Master’s thesis, Dalhousie University).
Nasser, J., Jesil, A., Mohiuddin, T., & others., 2013, Experimental investigation of drilling fluid performance as nanoparticles. World Journal of Nano Science and Engineering, vol. 3, pp.57–61.
Awele, N., 2014, Investigation of additives on drilling mud performance with Tonder geothermal drilling as a case study (Master’s thesis, Aalborg University, Esbjerg, Denmark).
Ogbeide, P. O., & Igbinere, S. A., 2016, The effect of additives on rheological properties of drilling fluid in highly deviated wells. FUTO Journal Series, vol. 2, no. 2, pp.68–82.
Yunita, P., Irawan, S., & Kania, D., 2016, Optimization of water-based drilling fluid using non-ionic and anionic surfactant additives. Procedia Engineering, vol. 148, pp.1184–1190.
Khodja, M., Khodja-Saber, M., Canselier, J. P., & others., 2010, Drilling fluid technology: Performances and environmental considerations. IntechOpen Access Publisher.
Ahmed, R., Nasir, S., & Silva, C., 2019, Drilling engineering: Problems and solutions. Gulf Professional Publishing.
Caenn, R., Darley, H. C. H., & Gray, G. R., 2017, Composition and properties of drilling and completion fluids (6th ed.). Gulf Professional Publishing.
Gupta, D. V. S., & Gupta, V., 2019, Hydraulic fracturing and well stimulation. Springer.
Nelson, E. B., & Guillot, D., 2006, Well cementing. Schlumberger.
Saboorian-Jooybari, H., Aghajanpour, R., & Dehghani, M., 2019, Rheological properties of drilling fluids: A comprehensive review. Journal of Petroleum Science and Engineering, vol. 173, pp.125–139.
Abduo, M. I., Dahab, A. S., Abuseda, H., & others., 2016, Comparative study of using water-based mud containing multiwall carbon nanotubes versus oil-based mud in HPHT fields. Egyptian Journal of Petroleum, vol. 25, pp.459–464.
Banfill, P. F. G., 2006, Rheology of fresh cement and concrete.
OFI Testing Equipment, Inc., 2017, Alkalinity of drilling fluids.
Schlumberger, 2023, Caustic soda. Retrieved from https://www.slb.com/products-and-services/innovating-in-oil-and-gas/well-construction/drilling-fluids/drilling-fluid-additives/alkalinity-control/caustic-soda
Gamal, H., Elkatatny, S., Basfar, S., & Al-Majed, A., 2019, Effect of pH on rheological and filtration properties of water-based drilling fluid based on bentonite. Sustainability, vol. 11, no. 23, 6714. https://doi.org/10.3390/su11236714
Borah, B. B., & Das, B. M., 2022, A review on applications of bio-products employed in drilling fluids to minimize environmental footprint. Environmental Challenges, 6, 100411. https://doi.org/10.1016/j.envc.2021.100411 Gamal, H., Elkatatny, S., Basfar, S., & Al-Majed, A. (2019). Effect of pH on Rheological and Filtration Properties of Water-Based Drilling Fluid Based on Bentonite. Sustainability, 11(23), 6714. https://doi.org/10.3390/su11236714 Ohia, N. P., Ndilemeni H., Ekwueme, S. T., 2022. Utilization of Indigenous pH Control Agents for Drilling Fluid Preparation, Zastita Materijala 63 (2) 128 – 134. https://doi.org/10.5937/zasmat2202128P. Martin, C., Babaie, M., Nourian, A., and G. G. Nasr, 2022. "Rheological Properties of the Water-Based Muds Composed of Silica Nanoparticle Under High Pressure and High
First Author et al. / Mechatronics, Electrical Power, and Vehicular Technology XX (20XX) XX-XX
© 2025 Oil and Gas Testing Center LEMIGAS All rights reserved
12
Temperature." SPE J. 27 (2022): 2563–2576. doi: https://doi.org/10.2118/209786-PA Ndubuisi, E. C., Anaele, J. V., Mofunlewi, S.S., 2020. Effect of Barite Concentrations on Oil Based Drilling Mud Density and Rheology, International Journal of Advanced Engineering Research and Science, Vol-7, Issue-12, December 2020 ). Rasan F., Ibtisam K., Namam S., Alain P., 2023. Optimum formulation design and properties of drilling fluids incorporated with green uncoated and polymer-coated magnetite nanoparticles, Arabian Journal of Chemistry, doi:10.1016/j.arabjc.2023.105492 Suhascaryo, N., & Dhaffa, F. M. (2024). Laboratory study on the use of local additive of clam shell in water based mud. Scientific Contributions Oil and Gas, 47(3), 205–213. https://doi.org/10.29017/SCOG.47.3.1635 Samura, L., Rosyidan, C., Maulani, M., Prima, A., Djumantara, M., Chusniyah, D. A., Fattahanisa, A., Satiyawira, B., Soekardy, M. G., & Brilliani. (2025). Optimization of alternative CMC sources from rice husk, sawdust, and caustic soda, and the effect of pH increase on filtration loss and rheology of drilling mud. Scientific Contributions Oil and Gas, 48(4), 129–145. https://doi.org/10.29017/scog.v48i4.1849 Suhascaryo, N., Ramadhanti, S. K., Wijaya, K. R., & Jannah, M. (2025). Comparative analysis of the use of nanosilica and potassium chloride as shale inhibitor in water based mud. Scientific Contributions Oil & Gas, 48(4), 229–250. https://journal.lemigas.esdm.go.id/index.php/SCOG/article/view/1768/1537
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors are free to Share — copy and redistribute the material in any medium or format for any purpose, even commercially Adapt — remix, transform, and build upon the material for any purpose, even commercially.
The licensor cannot revoke these freedoms as long as you follow the license terms, under the following terms Attribution — You must give appropriate credit , provide a link to the license, and indicate if changes were made . You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
No additional restrictions — You may not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
